Tech Support Knowledgebase Browse
 
Tools
Rss Categories

HN5A and HN5i Navigator - Latest version of OziExplorer [4WD mode] software

Author: Robert Taylor Reference Number: AA-00432 Views: 16450 Created: 2014-05-07 12:06 Last Updated: 2014-06-24 10:18 0 Rating/ Voters

Warning!

This download is specifically for the HN1, HN5A and HN5i model Navigators. Do not install this on HN6 or HN7 Navigators!  

Latest version: 2.41

You will find the latest version of the OziExplorer program as a download link at the bottom of this article.

You can find the current version of OziExplorer on your Navigator by checking in the bottom-right corner of the Settings page:

OziExplorer version number

To install this version, please do the following:

Ensure your Navigator is switched on and sitting at the Main Menu as shown below

Main Menu

Plug the Navigator in to the PC USB port, and make sure to use the Sync mode connection as shown below.

Configuring the HN5A and HN5i Navigators to use USB Windows Sync mode

Remember, to make the connection in ActiveSync, the HN5 model Navigators MUST be set to Sync Mode for the connection to work.

HN5A Navigator
HN5i Navigator
 Sync Mode icon When you first plug the Navigator into the PC USB port, the Mode Selection screen appears.
After plugging into the PC, the mode selection screen only appears for about 5 seconds.
Tap the Center GREEN button on the Navigator screen when the Navigator is first connected to the PC USB port.
If you do not choose one of the three modes, the Navigator defaults to the Sync Mode connection, so you can either tap the icon, or leave it to automatically connect in Sync Mode.

Make sure you have installed ActiveSync (WindowsXP) or Windows Mobile Device Center (Windows Vista, 7 or 8)

For information / help on ActiveSync or Windows Mobile Device Center, see one of these Knowledgebase articles:

Using Microsoft ActiveSync

Using Microsoft Windows Mobile Device Center

Download the installer program to your PC by clicking the button below.

Click here to download

  1. Connect your HN5 to the PC as detailed above.
  2. Run the installer program. It will advise you of its status.
  3. Disconnect your HN5 Navigator.
  4. Start the OziExplorer (4WD) program on your Navigator, and check the version on the Settings page as before to be sure it matches the version number shown at the top of this article.


Please rate articles! It helps us to ensure that you can find relevant information in the Knowledgebase.
You can use the Please rate this article option from the Tools menu at upper-right.
Comments left when rating articles are not replied to, although they are viewed and taken into account.
If you have an issue you need help with, please submit a ticket at Hema Tech Support

Content found in the Knowledgebase is accurate as at time of publication.
Copyright © 2015 Hema Maps Pty Ltd